Morse taper adaptor BT 40 - 1 - 50

Morse taper adaptor BT 40 - 1 - 50Application: For mounting tools with Morse taper shank and tang according to DIN 228 1 form B. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

A possible increase of axial force during the tapping process is reduced to a minimum

d = 40/d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079

Only nominal size d can be clamped

HSS-Co5 Twist drill DIN338 d=6

With clamping screw and axial adjustment bolt

clamping depth

For setting the tool in the HKS collet chucks

which can cause high frictional forces on the thread flanks

In NC machines (machines without automatic tool changers)

LSCX = Clamping depth

Not applicable with reductions

Application: