86038 Engine Flywheel 1pc 1/16 HSP Hi Speed Parts

86038 Engine Flywheel 1pc 1/16 HSP Hi Speed PartsTo suit HSP 1 16 scale models. Please check your manual for the correct part number to ensure a fit. Parts are plastic unless otherwise stated in the title. Images copyrighted by BlackSmith Products Ltd

12mm hex hub 46mm inner diameter (check the hub carrier is smaller than this) 64mm outer diameter

May fit other cars below is the measurements

Single speed Vented 1/10 scale metal clutch bell May also suit some 1/8 scale models 13 Teeth Uses (not included) 10mm x 5mm x 4mm bearings Inner diameter 26

Distance between center of fixed holes across top right top left is 27mm (same for all sides)

Their is two HSP pull starters available this is the for most recent made models

The platform can turn 360 degrees but unlike other work stations the stand can stop at 6 certain points instead of rotating freely

Decals attached as shown no extra decals included

Outside diameter x inside diameter x wide

77mm end to end when compressed

59mm end to end when compressed

Adjustable Tension Alloy Shocks with black coil spring

Each shoe features a built in bushing to enhance performance