Denali H-D Engine Bar Mount Kit For T3 Pods (Pair)

Denali H-D Engine Bar Mount Kit For T3 Pods (Pair)These low profile mounting adapters are made from durable gloss back ABS and allow you to seamlessly mount T3 Signal Pods to 1. 25" engine guards or crash bars commonly found on cruiser motorcycles. The mounting adapter is fixed to the bar with 3M VHB foam double stick tape creating the illusions that the T3 Signal Pods were built into the bar right from the factory. A channel allows the wire to exit the housing, but you can also run the wire inside

Wires length: 300 mm

Please see FLUHCBRF4R for the opposite fitment location

connect the unit to your bike

The tool marks clearly and accurately without any oil spray at full RPM

Each kit comes with a machined billet FI cleaner body

spoke angle and spoke nipple may need adjustment to suit this particular application

Battery saving mode prevents permanent battery damage

Reduces noise

Simple to use clip-on lock design

Cable management

Outside Diameter: 71mm

especially made for cleaning helmets and visors without stripes